Here is the cost analysis as a rule of thumb: For example how many 6” inch x 8” inch PCB boards can be coated with 1 liter of V2 Solution? Calculation is based on surface area - general rule is using the square inch of the PCB board x 0.16. Eg: 6 x 8 = 48 x 0.16 = 7.68 ml consumption rate - depending on the price per liter you sell for will be the price to coat each unit.

This is all predicated on the customer, delivery time, freight cost and customs clearance. We can typically fill orders in 2 -5 days depending on volume and container size the customer desires. Volumes come in 1, 5, 16 liter format, anything over this size will be too heavy to carry.

We're not allowed to take videos of customers facilities. We do have videos of a spray line, but robotics we don't.

Evaporation rate is about 1ml per 10 min based on the sample tray size at ambient. The evaporation rate is 0.0357 mL / cm^2/ hour. However, this will vary depending on the type of board disturbing the surface of the solution and also the solution's exposed area. After 5 hours total time of dipping boards using the same solution, it is recommended to purchase more solution as the solvent will evaporate off to the point where the solution is too concentrated. However, this can be experimentally streamlined if you want to use the same solution as one can continuously dilute the solution to maintain a specific concentration range

The durability of the coating has a lot to do with which type of coating it is and also it's environment. Generally we we can see up to 8+ years on outdoor electronics.

NanoFlowX advanced coating solutions can be used for all electronic devices, components, and sensors.

You can download a mutual NDA from us by clicking on the link here: Download